Skip to content
Fault code dictionary (DTC)

P266B — Bank 2 rocker arm actuator A position sensor range/performance

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe signal from the position sensor of rocker arm actuator 'A' on bank 2 is present, but it does not match what the computer expects. The cause may be the sensor or an actuator that is not moving as it should. Details depend on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Engine less responsive or weaker
Unstable idle
Mechanical noises from the cylinder head
Rising fuel consumption

Common causes

Slow, stuck or worn rocker arm actuator
Dirty, wrong-grade or low engine oil
Out-of-range or faulty position sensor
Electrical connections with high resistance
Insufficient oil pressure to the system

What to do

Check the oil level and condition right away, then the sensor and actuator on bank 2. Don't ignore it for long, since it may point to a mechanical part that is wearing out.

How to read code P266B

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P266B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (6B) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P266B mean?

Bank 2 rocker arm actuator A position sensor range/performance. The signal from the position sensor of rocker arm actuator 'A' on bank 2 is present, but it does not match what the computer expects. The cause may be the sensor or an actuator that is not moving as it should. Details depend on the manufacturer.

Can I keep driving with code P266B active?

With caution: limp mode possible, have it checked soon

Common causes — P266B

Slow, stuck or worn rocker arm actuator Dirty, wrong-grade or low engine oil Out-of-range or faulty position sensor Electrical connections with high resistance Insufficient oil pressure to the system

How do you fix code P266B?

Check the oil level and condition right away, then the sensor and actuator on bank 2. Don't ignore it for long, since it may point to a mechanical part that is wearing out.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes