P2670 — Actuator supply voltage B circuit low
| Meaning | The control unit measured that supply circuit B, which powers certain engine actuators, has a lower voltage than expected. Which actuators are on this circuit is decided by the manufacturer, so it cannot be stated in general. It means these components are not getting enough power to work properly. |
| Family | Powertrain (P) |
Typical symptoms
Low power or limp mode
Rough idle
Hard starting
Other codes involving actuators on the same circuit
Common causes
Connectors with corrosion or loose contacts
Supply wire broken or with high resistance
Missing or poor ground
Weak battery or charging system
One of the actuators shorted and pulling the voltage down
What to do
How to read code P2670
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2670 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (70) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2670 mean?
Actuator supply voltage B circuit low. The control unit measured that supply circuit B, which powers certain engine actuators, has a lower voltage than expected. Which actuators are on this circuit is decided by the manufacturer, so it cannot be stated in general. It means these components are not getting enough power to work properly.
Can I keep driving with code P2670 active?
With caution: limp mode possible, have it checked soon
Common causes — P2670
Supply fuse or relay in trouble Connectors with corrosion or loose contacts Supply wire broken or with high resistance Missing or poor ground Weak battery or charging system One of the actuators shorted and pulling the voltage down
How do you fix code P2670?
Start with the battery and its terminals, then check the fuses, relays and grounds tied to the circuit. If the battery is healthy, a workshop needs the wiring diagram for your car to find which components are connected. If the car goes into reduced power, avoid long trips.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P266F — A/C refrigerant distribution valve A control, driv...
- Next code: P2671 — Actuator supply voltage B circuit high
Related codes
- P2600 — Coolant pump control circuit: open
- P2601 — Coolant pump control circuit: out of range
- P2602 — Coolant pump control circuit: low
- P2603 — Coolant pump control circuit: high
- P2604 — Intake air heater A circuit: range/performance
- P2605 — Intake air heater A circuit: open
- P2606 — Intake air heater B circuit: range/performance
- P2607 — Intake air heater B circuit: low
- P2608 — Intake air heater B circuit: high
- P2609 — Intake air heater system performance
- P260A — PTO control circuit open
- P260B — PTO control circuit low