P2689 — Fuel supply heater: control circuit high
| Meaning | The control unit detected a higher voltage than expected in the fuel heater control circuit. Usually the wire is touching a power supply, or the circuit cannot pull to ground. The heater may stay on or may not respond to commands. |
| Family | Powertrain (P) |
Typical symptoms
Heater not switching off or not switching on
Hard starting in cold weather
Fuel getting hotter than it should
No obvious symptoms in some cases
Common causes
Heater relay stuck
Circuit ground corroded or disconnected
Heater with an internal fault
Engine control unit with a damaged output stage
What to do
How to read code P2689
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2689 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (89) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2689 mean?
Fuel supply heater: control circuit high. The control unit detected a higher voltage than expected in the fuel heater control circuit. Usually the wire is touching a power supply, or the circuit cannot pull to ground. The heater may stay on or may not respond to commands.
Can I keep driving with code P2689 active?
With caution: limp mode possible, have it checked soon
Common causes — P2689
Control wire touching a power supply Heater relay stuck Circuit ground corroded or disconnected Heater with an internal fault Engine control unit with a damaged output stage
How do you fix code P2689?
First check the relay, connector and ground connections of the heater. A heater stuck on can drain the battery and overheat the fuel. Have the circuit checked fairly soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2688 — Fuel supply heater: control circuit low
- Next code: P268A — Fuel injector calibration not learned or programme...
Related codes
- P2600 — Coolant pump control circuit: open
- P2601 — Coolant pump control circuit: out of range
- P2602 — Coolant pump control circuit: low
- P2603 — Coolant pump control circuit: high
- P2604 — Intake air heater A circuit: range/performance
- P2605 — Intake air heater A circuit: open
- P2606 — Intake air heater B circuit: range/performance
- P2607 — Intake air heater B circuit: low
- P2608 — Intake air heater B circuit: high
- P2609 — Intake air heater system performance
- P260A — PTO control circuit open
- P260B — PTO control circuit low