P2695 — Cylinder 10 injector data not compatible
| Meaning | The control unit compared the correction data for the cylinder 10 injector with what it expects, and they do not match. This usually happens after an injector or the control unit has been replaced and the calibration codes were not loaded or were loaded incorrectly. It only applies to engines with ten or more cylinders. |
| Family | Powertrain (P) |
Typical symptoms
Rough or jerky running
Loss of power
Hard starting
Unusual exhaust smoke
Engine running in reduced-power mode
Common causes
Control unit replaced or reprogrammed without the injector data
Correction code entered for the wrong cylinder
Injector not suitable for the engine
Error in the control unit memory
Wiring problem between the injector and the control unit
What to do
How to read code P2695
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2695 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (95) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2695 mean?
Cylinder 10 injector data not compatible. The control unit compared the correction data for the cylinder 10 injector with what it expects, and they do not match. This usually happens after an injector or the control unit has been replaced and the calibration codes were not loaded or were loaded incorrectly. It only applies to engines with ten or more cylinders.
Can I keep driving with code P2695 active?
With caution: limp mode possible, have it checked soon
Common causes — P2695
Injector replaced without programming its correction code Control unit replaced or reprogrammed without the injector data Correction code entered for the wrong cylinder Injector not suitable for the engine Error in the control unit memory Wiring problem between the injector and the control unit
How do you fix code P2695?
If an injector or the control unit was changed recently, first check that the correction codes were programmed. This needs a diagnostic tool suited to your make. Do not keep driving for long with a rough-running engine: have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2694 — Cylinder 9 injector data incompatible
- Next code: P2696 — Injector data not compatible
Related codes
- P2600 — Coolant pump control circuit: open
- P2601 — Coolant pump control circuit: out of range
- P2602 — Coolant pump control circuit: low
- P2603 — Coolant pump control circuit: high
- P2604 — Intake air heater A circuit: range/performance
- P2605 — Intake air heater A circuit: open
- P2606 — Intake air heater B circuit: range/performance
- P2607 — Intake air heater B circuit: low
- P2608 — Intake air heater B circuit: high
- P2609 — Intake air heater system performance
- P260A — PTO control circuit open
- P260B — PTO control circuit low