Skip to content
Fault code dictionary (DTC)

P26AC — Coolant bypass valve B control circuit open

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit sees no electrical continuity in the circuit that drives coolant bypass valve B. It is as if the wire were broken or the valve unplugged, so the command does not arrive. The valve cannot be managed properly.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Slow warm-up or unstable temperature
Weak cabin heating
Cooling fan running more than normal in some cases
Possible performance limitation

Common causes

Valve connector unplugged or corroded
Broken or damaged wire in the harness
Open coil or motor inside the valve
Spread or corroded connector terminals
Engine control unit driver output (rare)

What to do

First check the connector of valve B and any visible wiring for pinched or chafed wires. Get it checked soon: without valve control the engine may not manage its temperature well.

How to read code P26AC

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P26AC starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (AC) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P26AC mean?

Coolant bypass valve B control circuit open. The control unit sees no electrical continuity in the circuit that drives coolant bypass valve B. It is as if the wire were broken or the valve unplugged, so the command does not arrive. The valve cannot be managed properly.

Can I keep driving with code P26AC active?

With caution: limp mode possible, have it checked soon

Common causes — P26AC

Valve connector unplugged or corroded Broken or damaged wire in the harness Open coil or motor inside the valve Spread or corroded connector terminals Engine control unit driver output (rare)

How do you fix code P26AC?

First check the connector of valve B and any visible wiring for pinched or chafed wires. Get it checked soon: without valve control the engine may not manage its temperature well.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes