Skip to content
Fault code dictionary (DTC)

P26B6 — Fuel shutoff valve B control circuit stuck on

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected that valve B, which should shut off fuel, stays active or open when it should close. Position and system vary by manufacturer and I have no firm information for your brand. If it does not close, fuel may flow when it should not.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Fuel smell
Hard hot starting
Irregular running
Engine struggling to shut off

Common causes

Valve stuck from dirt
Faulty solenoid or internal spring
Electrical command always active because of a wiring fault
Connector with poor contacts
Engine control unit (rare)

What to do

If you smell fuel or notice leaks, do not use the car and have it checked immediately. Otherwise have the valve, connector and wiring checked soon.

How to read code P26B6

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P26B6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (B6) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P26B6 mean?

Fuel shutoff valve B control circuit stuck on. The control unit detected that valve B, which should shut off fuel, stays active or open when it should close. Position and system vary by manufacturer and I have no firm information for your brand. If it does not close, fuel may flow when it should not.

Can I keep driving with code P26B6 active?

With caution: limp mode possible, have it checked soon

Common causes — P26B6

Valve stuck from dirt Faulty solenoid or internal spring Electrical command always active because of a wiring fault Connector with poor contacts Engine control unit (rare)

How do you fix code P26B6?

If you smell fuel or notice leaks, do not use the car and have it checked immediately. Otherwise have the valve, connector and wiring checked soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes