Skip to content
Fault code dictionary (DTC)

P2777 — Upshift switch circuit voltage too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected a voltage that is too high in the upshift switch circuit. This usually points to an open circuit or a short to power. The manual upshift request is not read reliably.
FamilyPowertrain (P)

Typical symptoms

Upshift control does not respond
Transmission or check engine light on
Transmission switches to automatic or a limited mode
Manual shifting works only some of the time
Abnormal gear indicator on the dash

Common causes

Broken wire or unplugged connector
Corroded terminals in the connector
Faulty switch or paddle
Wire shorted to power
Faulty transmission control unit (uncommon)

What to do

First check the switch connections, looking for pulled wires or loose contacts. The car can be used in automatic, but have the circuit checked soon.

How to read code P2777

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2777 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (77) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2777 mean?

Upshift switch circuit voltage too high. The control unit detected a voltage that is too high in the upshift switch circuit. This usually points to an open circuit or a short to power. The manual upshift request is not read reliably.

Can I keep driving with code P2777 active?

With caution: limp mode possible, have it checked soon

Common causes — P2777

Broken wire or unplugged connector Corroded terminals in the connector Faulty switch or paddle Wire shorted to power Faulty transmission control unit (uncommon)

How do you fix code P2777?

First check the switch connections, looking for pulled wires or loose contacts. The car can be used in automatic, but have the circuit checked soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes