P278B — Kick-down switch range/performance
| Meaning | The control unit receives a signal from the kick-down switch that exists but does not match the pedal position or normal use. The circuit is not necessarily broken: the value is simply outside what is expected. |
| Family | Powertrain (P) |
Typical symptoms
Unintended downshifts
Irregular gear changes under acceleration
Transmission or check engine light on
Common causes
Pedal not reaching full travel, or a floor mat interfering
Connector with a weak contact
Wiring with abnormal resistance
Control unit fault
What to do
How to read code P278B
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P278B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (8B) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P278B mean?
Kick-down switch range/performance. The control unit receives a signal from the kick-down switch that exists but does not match the pedal position or normal use. The circuit is not necessarily broken: the value is simply outside what is expected.
Can I keep driving with code P278B active?
With caution: limp mode possible, have it checked soon
Common causes — P278B
Misadjusted or worn switch or pedal sensor Pedal not reaching full travel, or a floor mat interfering Connector with a weak contact Wiring with abnormal resistance Control unit fault
How do you fix code P278B?
Make sure nothing obstructs the pedal travel, such as a misplaced floor mat, then check the connector and wiring. It is usually not urgent, but the gearbox response under acceleration may be affected.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usRelated codes
- P2700 — Transmission friction element A apply time out of range
- P2701 — Transmission friction element B apply time out of range
- P2702 — Transmission friction element C apply time out of range
- P2703 — Transmission friction element D apply time out of range
- P2704 — Transmission friction element E apply time out of range
- P2705 — Transmission friction element F apply time out of range
- P2706 — Shift solenoid F: general fault
- P2707 — Shift solenoid F: performance or stuck off
- P2708 — Shift solenoid F: stuck on
- P2709 — Shift solenoid F: electrical fault
- P270A — Transmission friction element A temperature too high
- P270B — Transmission friction element B temperature too high