P27C4 — Pressure control solenoid P intermittent
| Meaning | The transmission control module detected that pressure control solenoid P works only part of the time: the problem appears and disappears. The code is standardized, but the letter P depends on the manufacturer, so without the make and model I can't say for sure which function it controls. Intermittent faults are often linked to electrical contacts that are lost with vibration or heat. |
| Family | Powertrain (P) |
Typical symptoms
Harsh or irregular shifts only at times
Transmission entering limp mode and then returning to normal
Problems more frequent on rough roads or when hot
Gears skipping or not engaging now and then
Common causes
Wiring with a damaged or chafed wire
Solenoid with a faulty coil that works intermittently
Contaminated transmission fluid
Unstable supply voltage or faulty ground
What to do
How to read code P27C4
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P27C4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (C4) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P27C4 mean?
Pressure control solenoid P intermittent. The transmission control module detected that pressure control solenoid P works only part of the time: the problem appears and disappears. The code is standardized, but the letter P depends on the manufacturer, so without the make and model I can't say for sure which function it controls. Intermittent faults are often linked to electrical contacts that are lost with vibration or heat.
Can I keep driving with code P27C4 active?
With caution: limp mode possible, have it checked soon
Common causes — P27C4
Transmission connector with unstable or corroded contact Wiring with a damaged or chafed wire Solenoid with a faulty coil that works intermittently Contaminated transmission fluid Unstable supply voltage or faulty ground
How do you fix code P27C4?
First check the transmission connectors and wiring, wiggling them with the system running to see if the fault shows up. Even if the problem comes and goes, don't ignore it: it can get worse and leave you with the transmission in limp mode.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P27C3 — Pressure control solenoid P electrical fault
- Next code: P27C5 — Pressure control solenoid P: control circuit open
Related codes
- P2700 — Transmission friction element A apply time out of range
- P2701 — Transmission friction element B apply time out of range
- P2702 — Transmission friction element C apply time out of range
- P2703 — Transmission friction element D apply time out of range
- P2704 — Transmission friction element E apply time out of range
- P2705 — Transmission friction element F apply time out of range
- P2706 — Shift solenoid F: general fault
- P2707 — Shift solenoid F: performance or stuck off
- P2708 — Shift solenoid F: stuck on
- P2709 — Shift solenoid F: electrical fault
- P270A — Transmission friction element A temperature too high
- P270B — Transmission friction element B temperature too high