Skip to content
Fault code dictionary (DTC)

P27D2 — Pressure control solenoid S: stuck on

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe transmission control unit has detected that pressure control solenoid S stays active even when it should close. Oil pressure for that function remains present when it should not. The role of the letter S varies with the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Transmission hard or seemingly locked in one gear
Strong jolts during shifts
Engine being held back as if two gears were engaged
Transmission in limp mode
Engine or transmission warning light on

Common causes

Solenoid or valve stuck by dirt or debris
Contaminated or heavily degraded transmission fluid
Internal wear in the valve body
Wiring keeping the command permanently active
Faulty transmission control unit (rare)

What to do

Check the level, colour and smell of the transmission fluid. If the transmission locks up or jolts hard, have it checked soon, because using it further can make the damage worse.

How to read code P27D2

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P27D2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (D2) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P27D2 mean?

Pressure control solenoid S: stuck on. The transmission control unit has detected that pressure control solenoid S stays active even when it should close. Oil pressure for that function remains present when it should not. The role of the letter S varies with the manufacturer.

Can I keep driving with code P27D2 active?

With caution: limp mode possible, have it checked soon

Common causes — P27D2

Solenoid or valve stuck by dirt or debris Contaminated or heavily degraded transmission fluid Internal wear in the valve body Wiring keeping the command permanently active Faulty transmission control unit (rare)

How do you fix code P27D2?

Check the level, colour and smell of the transmission fluid. If the transmission locks up or jolts hard, have it checked soon, because using it further can make the damage worse.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes