Skip to content
Fault code dictionary (DTC)

P2A6C — Alt. fuel regulator inlet pressure sensor: high signal

Severity: Serious Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit reads too high a voltage from the circuit of the alternative fuel regulator inlet pressure sensor. This is usually caused by a wire shorted to the supply, an open ground or a failed sensor. Again, the code concerns the signal, not the actual pressure.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Gas unusable or limited
Uneven running on gas
Loss of power
Forced return to the main fuel

Common causes

Wire shorted to the supply
Open or corroded sensor ground
Damaged connector
Faulty pressure sensor
Internal control unit problem, rare

What to do

Have the sensor ground and wiring checked first, then the sensor itself. You can generally use the main fuel in the meantime, avoiding gas until the circuit has been verified.

How to read code P2A6C

This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.

The code P2A6C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (6C) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2A6C mean?

Alt. fuel regulator inlet pressure sensor: high signal. The control unit reads too high a voltage from the circuit of the alternative fuel regulator inlet pressure sensor. This is usually caused by a wire shorted to the supply, an open ground or a failed sensor. Again, the code concerns the signal, not the actual pressure.

Can I keep driving with code P2A6C active?

With caution: limp mode possible, have it checked soon

Common causes — P2A6C

Wire shorted to the supply Open or corroded sensor ground Damaged connector Faulty pressure sensor Internal control unit problem, rare

How do you fix code P2A6C?

Have the sensor ground and wiring checked first, then the sensor itself. You can generally use the main fuel in the meantime, avoiding gas until the circuit has been verified.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes