P2A70 — Alt. fuel hydraulic pump select valve: control circuit fault
| Meaning | The control unit found an electrical problem in the circuit that drives the hydraulic fuel pump select valve of the alternative fuel system. This is a specialised, uncommon system and its exact operation depends on the manufacturer, so I cannot describe it in more detail without knowing the vehicle. |
| Family | Powertrain (P) |
Typical symptoms
Alternative fuel unusable
Power loss on gas
Hard starting on gas
Switching to the main fuel
Common causes
Broken or shorted wire
Faulty valve coil
Faulty circuit supply or ground
Internal control unit problem, rare
What to do
How to read code P2A70
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2A70 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (A) points to hybrid propulsion, and the last two (70) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2A70 mean?
Alt. fuel hydraulic pump select valve: control circuit fault. The control unit found an electrical problem in the circuit that drives the hydraulic fuel pump select valve of the alternative fuel system. This is a specialised, uncommon system and its exact operation depends on the manufacturer, so I cannot describe it in more detail without knowing the vehicle.
Can I keep driving with code P2A70 active?
With caution: limp mode possible, have it checked soon
Common causes — P2A70
Damaged or corroded valve connector Broken or shorted wire Faulty valve coil Faulty circuit supply or ground Internal control unit problem, rare
How do you fix code P2A70?
Check the valve connector and wiring and have the circuit measured. In the meantime use the main fuel and avoid gas until the fault is resolved.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2A6F — Alt. fuel regulator inlet pressure too high
- Next code: P2A71 — Alt. fuel hydraulic pump select valve: performance...
Related codes
- P2A00 — O2 sensor circuit range/performance, bank 1 sensor 1
- P2A01 — O2 sensor circuit range/performance, bank 1 sensor 2
- P2A02 — O2 sensor circuit range/performance, bank 1 sensor 3
- P2A03 — O2 sensor circuit range/performance, bank 2 sensor 1
- P2A04 — Bank 2 Sensor 2 oxygen sensor signal not plausible
- P2A05 — Bank 2 Sensor 3 oxygen sensor signal not plausible
- P2A06 — Bank 1 Sensor 1 oxygen sensor negative voltage
- P2A07 — Bank 1 Sensor 2 oxygen sensor negative voltage
- P2A08 — Bank 1 Sensor 3 oxygen sensor negative voltage
- P2A09 — Bank 2 Sensor 1 oxygen sensor negative voltage
- P2A0A — Manifold pressure sensor B circuit fault
- P2A0B — Manifold pressure sensor B signal not plausible