Skip to content
Fault code dictionary (DTC)

P2B1C — Cylinder 7 injection pulse offset not learned

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit has not yet stored the injection pulse correction value for cylinder 7. This correction compensates for small differences between injectors. It typically appears after an injector or control unit has been replaced, or after stored data has been lost. The exact way the learning is performed depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Rough running, especially at idle
Slightly less smooth acceleration
Starting takes a little longer than usual
Smoke or smell of imperfect combustion

Common causes

Injector on cylinder 7 replaced without running the learning procedure
Control unit replaced, reprogrammed or updated without learning
Stored data erased after battery disconnection or discharge
Learning procedure interrupted or not completed
Wiring or communication problem with the injector

What to do

If an injector or the control unit was recently replaced, the missing learning is the most likely cause: a diagnostic tool suited to your make is needed to run it. If nothing was changed, have the injector and its wiring checked. You can drive carefully for short trips, but do not put it off for long.

How to read code P2B1C

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2B1C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (1C) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2B1C mean?

Cylinder 7 injection pulse offset not learned. The control unit has not yet stored the injection pulse correction value for cylinder 7. This correction compensates for small differences between injectors. It typically appears after an injector or control unit has been replaced, or after stored data has been lost. The exact way the learning is performed depends on the manufacturer.

Can I keep driving with code P2B1C active?

With caution: limp mode possible, have it checked soon

Common causes — P2B1C

Injector on cylinder 7 replaced without running the learning procedure Control unit replaced, reprogrammed or updated without learning Stored data erased after battery disconnection or discharge Learning procedure interrupted or not completed Wiring or communication problem with the injector

How do you fix code P2B1C?

If an injector or the control unit was recently replaced, the missing learning is the most likely cause: a diagnostic tool suited to your make is needed to run it. If nothing was changed, have the injector and its wiring checked. You can drive carefully for short trips, but do not put it off for long.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes