P2C96 — Hybrid/EV battery disable circuit: open
| Meaning | The battery control unit detected an open circuit, meaning a break, in the wiring used to cut off the high-voltage battery when needed. The safety check cannot confirm that the command works, so the system may limit or block electric operation. The exact way this circuit is built differs from one manufacturer to another. |
| Family | Powertrain (P) |
Typical symptoms
Car will not start in electric mode or will not enter Ready
Reduced power or running on the combustion engine only
High-voltage system fault message
Charging not possible or interrupted
Common causes
Broken or damaged wire in the harness
Internal fault in the battery management module
Faulty battery contactor or safety relay
Earlier work on the system with a connector not refitted properly
What to do
How to read code P2C96
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2C96 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (96) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2C96 mean?
Hybrid/EV battery disable circuit: open. The battery control unit detected an open circuit, meaning a break, in the wiring used to cut off the high-voltage battery when needed. The safety check cannot confirm that the command works, so the system may limit or block electric operation. The exact way this circuit is built differs from one manufacturer to another.
Can I keep driving with code P2C96 active?
With caution: limp mode possible, have it checked soon
Common causes — P2C96
Loose or corroded connector on the disable circuit Broken or damaged wire in the harness Internal fault in the battery management module Faulty battery contactor or safety relay Earlier work on the system with a connector not refitted properly
How do you fix code P2C96?
Have the code read at a workshop with a full diagnosis, because this circuit is part of the high-voltage safety system. Do not touch orange cables or battery pack connectors: that work is for qualified staff. If the car will not start or the light is red, do not keep trying and have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2C95 — Hybrid/EV battery contactor control supply circuit...
- Next code: P2C97 — Hybrid/EV battery disable circuit: low signal
Related codes
- P2C00 — Fuel pressure regulator C performance fault
- P2C01 — Fuel pressure regulator D performance fault
- P2C02 — Fuel pressure regulator D control circuit open
- P2C03 — Fuel pressure regulator D control shorted to ground
- P2C04 — Fuel pressure regulator D control shorted to supply
- P2C05 — Camshaft profile actuator position sensor A circuit, bank 1
- P2C06 — Camshaft profile actuator position sensor A range fault, ban...
- P2C07 — Camshaft profile actuator position sensor A low, bank 1
- P2C08 — Camshaft profile actuator position sensor A high, bank 1
- P2C09 — Camshaft profile actuator position sensor B circuit, bank 1
- P2C0A — Cam profile actuator A sensor B: range/performance, bank 1
- P2C0B — Cam profile actuator A sensor B: circuit low, bank 1