P3418 — Cylinder 3 deactivation/intake valve control performance
| Meaning | The control unit found that the cylinder 3 intake valve or deactivation system is not responding as commanded. The electrical circuit may be normal, but the actual movement doesn't match the request. The component depends on make and engine. |
| Family | Powertrain (P) |
Typical symptoms
Rough running or jerking
Loss of power
Cylinder deactivation not behaving correctly
Unusual noises from the valve area
Common causes
Oil level or pressure not adequate
Dirty or wrong-spec oil blocking passages
Mechanical wear in the valve mechanism
Wiring or connector with a weak contact
What to do
How to read code P3418
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P3418 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (4) points to auxiliary emission controls, and the last two (18) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P3418 mean?
Cylinder 3 deactivation/intake valve control performance. The control unit found that the cylinder 3 intake valve or deactivation system is not responding as commanded. The electrical circuit may be normal, but the actual movement doesn't match the request. The component depends on make and engine.
Can I keep driving with code P3418 active?
With caution: limp mode possible, have it checked soon
Common causes — P3418
Sluggish or stuck actuator or solenoid Oil level or pressure not adequate Dirty or wrong-spec oil blocking passages Mechanical wear in the valve mechanism Wiring or connector with a weak contact
How do you fix code P3418?
Check engine oil level and condition first, then have the component diagnosed. Avoid heavy loads until it has been verified.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P3417 — Cylinder 3 deactivation/intake valve control circu...
- Next code: P3419 — Cylinder 3 deactivation/intake valve control circu...
Related codes
- P3400 — Cylinder deactivation system, bank 1
- P3401 — Cylinder 1 deactivation/intake valve control circuit open
- P3402 — Cylinder 1 deactivation/intake valve control performance
- P3403 — Cylinder 1 deactivation/intake valve control circuit low
- P3404 — Cylinder 1 deactivation/intake valve control circuit high
- P3405 — Cylinder 1 exhaust valve control circuit open
- P3406 — Cylinder 1 exhaust valve control performance
- P3407 — Cylinder 1 exhaust valve control circuit low
- P3408 — Cylinder 1 exhaust valve control circuit high
- P3409 — Cylinder 2 deactivation/intake valve control circuit open
- P340A — Deactivation/intake valve control circuit, bank 1
- P340B — Deactivation/intake valve control circuit, bank 2