Skip to content
Fault code dictionary (DTC)

P3474 — Cylinder 10 deactivation/intake valve control: performance problem

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit found that the deactivation system or the intake valve on cylinder 10 is not responding to the command as expected. The electrical circuit may be fine, but the movement is slower, incomplete or missing. The exact meaning depends on the system fitted.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Rough running or vibration
Loss of power
Unusual noises from the valve area
Unstable idle
The cylinder doesn't deactivate or reactivate as it should

Common causes

Dirty, low or wrong-grade engine oil
Low oil pressure in the actuator circuit
Stuck or slow actuator or solenoid
Worn or seized valve mechanism
Electrical connection with too much resistance
Mechanical valve train problem (rare)

What to do

Check the oil level and condition right away, then have the actuator and mechanism on cylinder 10 inspected. If you hear mechanical noises or notice a strong loss of power, avoid pushing the engine. Don't clear the code to make it go away.

How to read code P3474

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P3474 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the manufacturer, so the exact meaning can change from make to make. The third character (4) points to auxiliary emission controls, and the last two (74) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P3474 mean?

Cylinder 10 deactivation/intake valve control: performance problem. The control unit found that the deactivation system or the intake valve on cylinder 10 is not responding to the command as expected. The electrical circuit may be fine, but the movement is slower, incomplete or missing. The exact meaning depends on the system fitted.

Can I keep driving with code P3474 active?

With caution: limp mode possible, have it checked soon

Common causes — P3474

Dirty, low or wrong-grade engine oil Low oil pressure in the actuator circuit Stuck or slow actuator or solenoid Worn or seized valve mechanism Electrical connection with too much resistance Mechanical valve train problem (rare)

How do you fix code P3474?

Check the oil level and condition right away, then have the actuator and mechanism on cylinder 10 inspected. If you hear mechanical noises or notice a strong loss of power, avoid pushing the engine. Don't clear the code to make it go away.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes