U0651 — Lost communication with EGR sensor A
| Meaning | The control unit no longer receives data from sensor A of the EGR system, which recirculates part of the exhaust gas into the intake to reduce emissions. The sensor is not answering on the network. The code is standard, but which sensor counts as A depends on the manufacturer. |
| Family | Network (U) |
Typical symptoms
Rough idle or engine stalling
Loss of power
Darker exhaust smoke than normal
Higher emissions at the inspection
Common causes
Damaged wiring or weak contacts
Faulty EGR sensor
Dirty or stuck EGR valve
Insufficient power or ground
Fault on the data network or in the control unit
What to do
How to read code U0651
This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.
The code U0651 starts with U: it belongs to the network and communication between control units area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code U0651 mean?
Lost communication with EGR sensor A. The control unit no longer receives data from sensor A of the EGR system, which recirculates part of the exhaust gas into the intake to reduce emissions. The sensor is not answering on the network. The code is standard, but which sensor counts as A depends on the manufacturer.
Can I keep driving with code U0651 active?
With caution: limp mode possible, have it checked soon
Common causes — U0651
Corroded or loose sensor connector Damaged wiring or weak contacts Faulty EGR sensor Dirty or stuck EGR valve Insufficient power or ground Fault on the data network or in the control unit
How do you fix code U0651?
Check the sensor wiring and connector, then have the EGR valve inspected. The car can usually be driven for short trips, but the diagnosis should not be put off for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: U0650 — Lost communication with exhaust pressure control v...
- Next code: U0652 — Lost communication with EGR sensor B
Related codes
- U0600 — Lost Communication with Control Module
- U0601 — Lost Communication with Internal Control Module A
- U0602 — Lost Communication With Fuel Injector Control Module
- U0603 — Lost Communication With Actuator Control Module B
- U0604 — Lost Communication with Actuator Control Module 'A'
- U0605 — Lost communication with A/C refrigerant sensor A
- U0606 — Lost communication with throttle/pedal position sensor A
- U0607 — Lost communication with throttle/pedal position sensor B
- U0608 — Lost communication with throttle/pedal position sensor C
- U0609 — Lost communication with manifold/barometric pressure sensor
- U060A — Lost communication with manifold pressure sensor B
- U060B — Lost communication with turbo boost pressure sensor A