100 — Cruise Control Adjustment Fault
| Meaning | Cruise Control Adjustment Fault. |
| System | DDE 2.2 |
| Family | Manufacturer-native code |
How to read code 100
Code 100 is a native BMW code of the "DDE 2.2" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 100 mean?
Cruise Control Adjustment Fault. (System: DDE 2.2)
Can I keep driving with code 100 active?
With caution: limp mode possible, have it checked soon
How do you fix code 100?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (DDE 2.2)
- 01 — Delivery Controller Deviation
- 03 — Shut off Valve
- 04 — Glow Plug Indicator Lamp)
- 05 — Needle Motion Sensor
- 06 — Exhaust Gas Recirculation Deviation
- 07 — Exhaust Gas Recirculation
- 08 — Glow Plug Timing Control
- 09 — DDE Error
- 10 — Injection Phasing Control Deviation
- 101 — Boost Pressure Control Deviation
Related codes
- 10 — Speed Regulator
- 10 — Injection Phasing Control Deviation
- 10 — Injection Phasing Control Deviation
- 10 — DDE Power Supply
- 10 — Lambda Regulation
- 10 — Lambda Sensor Pre Cat Bank 1 Signal
- 10 — AirCon Pressure Switch
- 10 — Coolant Temperature Sensor
- 100 — DME Control Unit Final Stage
- 100 — Control Unit Fault
- 100 — DME Control Unit SelfTest Failed
- 101 — Boost Pressure Control Deviation