113 — CAN Error ASC Control Unit
| Meaning | CAN Error ASC Control Unit. |
| System | DDE 2.2 |
| Family | Manufacturer-native code |
How to read code 113
Code 113 is a native BMW code of the "DDE 2.2" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 113 mean?
CAN Error ASC Control Unit. (System: DDE 2.2)
Can I keep driving with code 113 active?
With caution: limp mode possible, have it checked soon
How do you fix code 113?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (DDE 2.2)
- 01 — Delivery Controller Deviation
- 03 — Shut off Valve
- 04 — Glow Plug Indicator Lamp)
- 05 — Needle Motion Sensor
- 06 — Exhaust Gas Recirculation Deviation
- 07 — Exhaust Gas Recirculation
- 08 — Glow Plug Timing Control
- 09 — DDE Error
- 10 — Injection Phasing Control Deviation
- 100 — Cruise Control Adjustment Fault
Related codes
- 11 — DDE Error
- 11 — DDE Error
- 11 — DDE Low Voltage
- 11 — Front Left ABS Valve
- 11 — Tank Pressure Sensor (EVAP System) or Radiator Outlet Temp (...
- 110 — AirCon Poor Operation
- 110 — Torque Monitoring
- 110 — Pedal Sensor Value Potentiometer 1
- 111 — EEPROM checksum Injection Pump Adaptation
- 111 — Crankshaft Sensor Signal
- 111 — Pedal Sensor Value Potentiometer 2
- 112 — CAN Error EGS Control Unit