195 — EVAP Small Leak Detected
| Meaning | EVAP Small Leak Detected. |
| System | MS41 |
| Family | Manufacturer-native code |
How to read code 195
Code 195 is a native BMW code of the "MS41" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 195 mean?
EVAP Small Leak Detected. (System: MS41)
Can I keep driving with code 195 active?
With caution: limp mode possible, have it checked soon
How do you fix code 195?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (MS41)
- 1 — Ignition coil Cyl 2
- 10 — Coolant Temperature Sensor
- 100 — DME Control Unit SelfTest Failed
- 101 — Tyre Pressure Front Right
- 102 — Tyre Pressure Rear Right
- 103 — VANOS Error Inlet Camshaft
- 104 — VANOS Error Exhaust Camshaft
- 105 — VANOS Error Position Inlet Camshaft
- 106 — VANOS Error Position Exhaust Camshaft
- 107 — Electronic Throttle Self Test
- Previous code: 194 — EVAP Large Leak Detected
- Next code: 196 — EVAP Electrical Valve from LDP Pump or Barometric...
Related codes
- 19 — Electric Fan Output Stage
- 19 — Activation VANOS Inlet Valve or Exhaust Valve (MS43)
- 190 — EVAP Reed Switch Open or Voltage Post Cat Bank 1 (MS43)
- 191 — EVAP Reed Switch Closed or Voltage Post Cat Bank 2 (MS43)
- 192 — EVAP Reed Switch Open
- 193 — DME Ignition Signal
- 193 — EVAP Check Hoses
- 194 — EVAP Large Leak Detected
- 196 — EVAP Electrical Valve from LDP Pump or Barometric Pressure S...
- 197 — EVAP Barometric Pressure Sensor
- 198 — Cat Efficiency during Start Bank 1
- 199 — Cat Efficiency during Start Bank 2