2 — Fuel Temperature Sensor
| Meaning | Fuel Temperature Sensor. |
| System | DDE 1 |
| Family | Manufacturer-native code |
How to read code 2
Code 2 is a native BMW code of the "DDE 1" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 2 mean?
Fuel Temperature Sensor. (System: DDE 1)
Can I keep driving with code 2 active?
With caution: limp mode possible, have it checked soon
How do you fix code 2?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (DDE 1)
- 1 — RPM Sensor
- 10 — Speed Regulator
- 11 — DDE Error
- 13 — RPM Signal
- 14 — Injection Phasing Sensor
- 15 — Exhaust Gas Recirculation
- 16 — Injection Phasing Regulator
- 17 — Brake Light Test Switch
- 3 — Coolant Temperature Sensor
- 36 — Coolant Level Sensor
Related codes
- 2 — IdleSpeed Controller
- 2 — DMTL Output Stage Solenoid Valve
- 2 — Ignition Fault Cylinder 3
- 2 — Ignition coil Cyl 4
- 20 — Cruise Control Switch
- 20 — Cruise Control Operation
- 20 — Cruise Control Operation
- 20 — Cruise Control
- 20 — Lambda Sensor Post Cat Bank 2 Signal
- 20 — "CHECK ENGINE" Light Failure
- 200 — DME Control Unit
- 200 — Lambda Sensor Control