21 — Injection Pump Position Potentiometer
| Meaning | Injection Pump Position Potentiometer. |
| System | DDE 2 |
| Family | Manufacturer-native code |
How to read code 21
Code 21 is a native BMW code of the "DDE 2" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 21 mean?
Injection Pump Position Potentiometer. (System: DDE 2)
Can I keep driving with code 21 active?
With caution: limp mode possible, have it checked soon
How do you fix code 21?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (DDE 2)
- 1 — Injection Pump Mass Positioner
- 10 — Injection Phasing Control Deviation
- 15 — Voltage Supply DDE
- 20 — Cruise Control Switch
- 28 — Clutch switch
- 29 — Vehicle Speed Signal
- 3 — Shut off Valve
- 31 — Brake Switch
- 35 — Fuel Temperature Sensor
- 36 — Fuel Filter Water Trap
Related codes
- 21 — DDE Error
- 21 — Front Left Wheel Sensor or ABS/ASC ECU Fault
- 21 — Lambda Sensor Timing Pre Cat Bank 2 (TP)
- 21 — VANOS Electrical Fault or Activation VANOS Inlet Valve (MS43...
- 210 — CAN Interface
- 210 — Knock Sensor Signal 1
- 210 — Ignition Feedback Resistor (ZSR)
- 211 — Knock Sensor Signal 2
- 211 — Idle Speed Actuator Mechanical
- 212 — Knock Sensor Signal 3
- 212 — VANOS Bank 1 Mechanical
- 213 — Knock Sensor Signal 4