219 — CAN Timeout TCU
| Meaning | CAN Timeout TCU. |
| System | DME 7.2 |
| Family | Manufacturer-native code |
How to read code 219
Code 219 is a native BMW code of the "DME 7.2" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 219 mean?
CAN Timeout TCU. (System: DME 7.2)
Can I keep driving with code 219 active?
With caution: limp mode possible, have it checked soon
How do you fix code 219?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (DME 7.2)
- 1 — Leak Diagnosis Pump
- 10 — Lambda Sensor Pre Cat Bank 1 Signal
- 101 — Torque Monitoring
- 102 — Multifunction Steering Wheel Signal
- 103 — Control Unit Monitoring
- 104 — Clutch Switch Signal
- 105 — Control Unit Fault (RAM)
- 106 — Brake Switch Signal
- 107 — Control Unit Fault (ROM)
- 108 — Reset DME / Voltage Supply
Related codes
- 21 — Injection Pump Position Potentiometer
- 21 — DDE Error
- 21 — Front Left Wheel Sensor or ABS/ASC ECU Fault
- 21 — Lambda Sensor Timing Pre Cat Bank 2 (TP)
- 21 — VANOS Electrical Fault or Activation VANOS Inlet Valve (MS43...
- 210 — CAN Interface
- 210 — Knock Sensor Signal 1
- 210 — Ignition Feedback Resistor (ZSR)
- 211 — Knock Sensor Signal 2
- 211 — Idle Speed Actuator Mechanical
- 212 — Knock Sensor Signal 3
- 212 — VANOS Bank 1 Mechanical