255 — DME Control Unit Internal Error
| Meaning | DME Control Unit Internal Error. |
| System | DDE 5 |
| Family | Manufacturer-native code |
How to read code 255
Code 255 is a native BMW code of the "DDE 5" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 255 mean?
DME Control Unit Internal Error. (System: DDE 5)
Can I keep driving with code 255 active?
With caution: limp mode possible, have it checked soon
How do you fix code 255?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (DDE 5)
- 1 — DME Fault
- 10 — Lambda Regulation
- 100 — DME Control Unit Final Stage
- 101 — DME Plausibility Engine Inoperable
- 103 — Brake Light Switch
- 104 — Steering Angle Sensor
- 105 — Brake Light Switch
- 106 — Lateral Acceleration Sensor
- 107 — RPM sensor (Gradient)
- 11 — Front Left ABS Valve
- Previous code: 254 — Tank Ventilation System Large Air Leak
- Next code: 26 — Brake Light Switch or Brake Light Test Switch
Related codes
- 25 — Pedal Position Sensor
- 25 — Pedal Position Sensor
- 25 — Ignition Fault Cyl 1 or 5
- 25 — Multiplicative Adaptation Bank 2 Control Limit Reached
- 25 — Vanos
- 25 — Lambda Sensor Heater Bank 1
- 250 — Tank Venting Valve Function
- 251 — Tank Ventilation Diagnosis Error
- 252 — DME Control Unit
- 252 — Tank Ventilation System Vacuum
- 253 — Activated Charcoal Filter Shutoff Valve Stuck Shut
- 254 — Tank Ventilation System Large Air Leak