Skip to content
Fault code dictionary (DTC)

C1908 — Left rear shock actuator shorted to ground

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThis code is manufacturer-defined. The control unit read a voltage that is too low in the left rear shock actuator circuit, as if the wire were touching ground. The exact meaning depends on the brand.
FamilyChassis (C)

Typical symptoms

Ride control fault light or message
Suspension stuck at a fixed setting
Left rear reacts differently from the others
More body roll in corners

Common causes

Worn wire insulation touching the body or suspension arm
Wet or corroded connector
Faulty shock absorber actuator
Fault in the ride control unit

What to do

Check the wiring route near the left rear wheel, especially where it rubs or bends. Have the car checked within a reasonable time and drive carefully in corners.

How to read code C1908

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code C1908 starts with C: it belongs to the chassis (brakes, steering, suspension) area. It is defined by the manufacturer, so the exact meaning can change from make to make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code C1908 mean?

Left rear shock actuator shorted to ground. This code is manufacturer-defined. The control unit read a voltage that is too low in the left rear shock actuator circuit, as if the wire were touching ground. The exact meaning depends on the brand.

Can I keep driving with code C1908 active?

With caution: limp mode possible, have it checked soon

Common causes — C1908

Worn wire insulation touching the body or suspension arm Wet or corroded connector Faulty shock absorber actuator Fault in the ride control unit

How do you fix code C1908?

Check the wiring route near the left rear wheel, especially where it rubs or bends. Have the car checked within a reasonable time and drive carefully in corners.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes