1007 — Trip Drive Fuel Used (Natural Gas)
| Meaning | Trip Drive Fuel Used (Natural Gas). |
| System | ZBR2 |
| Family | Manufacturer-native code |
How to read code 1007
Code 1007 is a native MAN code of the "ZBR2" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 1007 mean?
Trip Drive Fuel Used (Natural Gas). (System: ZBR2)
Can I keep driving with code 1007 active?
With caution: limp mode possible, have it checked soon
How do you fix code 1007?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (ZBR2)
- 1031 — Trip Average Fuel Rate (Natural Gas)
- 1676 — No 'Break light request' signal in ERC_RX (timeout)
- 2987 — Parameter record in central on-board computer 2
- 3000 — ZBR system
- 3001 — Wake up, computer
- 3102 — ZBR power supply
- 3103 — Analog ground
- 3104 — Analog ground
- 3107 — Ignition ON (relay tl. 15)
- 3108 — Electrical battery master switch
Related codes
- 10 — Motor/door valve door 3 (rear)
- 10 — Engaged gear
- 100 — Oil pressure
- 102 — Boost pressure
- 1031 — Trip Average Fuel Rate (Natural Gas)
- 1042 — ISO 11992 (trailer CAN): Data bus switched off
- 1043 — Supply voltage for peripherals
- 1045 — Gate interlock
- 105 — Charge air temperature
- 1056 — Trailer control module pressure control,
- 1057 — Central control unit - B-controller
- 1058 — Trailer control module - pressure sensor signal