228 — Speed speedometer and sensor
| Meaning | Speed speedometer and sensor. |
| System | RAS |
| Family | Manufacturer-native code |
How to read code 228
Code 228 is a native MAN code of the "RAS" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 228 mean?
Speed speedometer and sensor. (System: RAS)
Can I keep driving with code 228 active?
With caution: limp mode possible, have it checked soon
How do you fix code 228?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (RAS)
- 3076 — Oil level check
- 3077 — Comparison between tachometer / EBC speed signal
- 3078 — CAN signal speed speedometer
- 3081 — CAN signal road speed EBC
- 3082 — CAN signal engine speed
- 3083 — CAN signal weight
- 3084 — CAN signal lifting axle
- 3085 — CAN signal parking brake
- 3086 — CAN signal bus transmitter/receiver
- 3087 — Parameter value calibration