3047 — Engine interface, adjustment lever angle increase input,
| Meaning | Engine interface, adjustment lever angle increase input,. |
| System | EBS |
| Family | Manufacturer-native code |
How to read code 3047
Code 3047 is a native MAN code of the "EBS" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 3047 mean?
Engine interface, adjustment lever angle increase input,. (System: EBS)
Can I keep driving with code 3047 active?
With caution: limp mode possible, have it checked soon
How do you fix code 3047?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (EBS)
- 1042 — ISO 11992 (trailer CAN): Data bus switched off
- 1056 — Trailer control module pressure control,
- 1057 — Central control unit - B-controller
- 1058 — Trailer control module - pressure sensor signal
- 1060 — Brake pad wear sensor signal wheel 1
- 1061 — Brake pad wear sensor signal wheel 2
- 1062 — Brake pad wear sensor signal wheel 3
- 1063 — Brake pad wear sensor signal wheel 4
- 1064 — Brake pad wear sensor signal wheel 5
- 1065 — Brake pad wear sensor signal wheel 6
- Previous code: 3046 — Angle encoder, steering axle 1, track 2
- Next code: 3048 — Overrun test undervoltage monitoring
Related codes
- 30 — Stop request display door 1
- 3000 — No fault
- 3000 — Electronics error function computer
- 3000 — CAN data bus: Time overrun when receiving
- 3000 — Temperature at outfeed of evaporator (KTT n. KTBV)
- 3000 — An unexpected RESET has occurred
- 3000 — Tyre pressure
- 3000 — ZBR system
- 3001 — Additional information 1
- 3001 — Control unit defective; unknown µC interrupt,
- 3001 — Control unit (internal fault)
- 3001 — Engine speed sensor, reverse polarity