3239 — Pressure control module, left rear axle
| Meaning | Pressure control module, left rear axle. |
| System | EBS |
| Family | Manufacturer-native code |
How to read code 3239
Code 3239 is a native MAN code of the "EBS" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 3239 mean?
Pressure control module, left rear axle. (System: EBS)
Can I keep driving with code 3239 active?
With caution: limp mode possible, have it checked soon
How do you fix code 3239?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (EBS)
- 1042 — ISO 11992 (trailer CAN): Data bus switched off
- 1056 — Trailer control module pressure control,
- 1057 — Central control unit - B-controller
- 1058 — Trailer control module - pressure sensor signal
- 1060 — Brake pad wear sensor signal wheel 1
- 1061 — Brake pad wear sensor signal wheel 2
- 1062 — Brake pad wear sensor signal wheel 3
- 1063 — Brake pad wear sensor signal wheel 4
- 1064 — Brake pad wear sensor signal wheel 5
- 1065 — Brake pad wear sensor signal wheel 6
Related codes
- 32 — Split position
- 32 — Stop request display door 3
- 3200 — Pressure control module, left rear axle, no fault
- 3200 — Supply voltage / feedback, solenoid valves
- 3200 — CAN data bus: Astronic message ETC1, byte 4
- 3201 — Pressure control module, left rear axle,
- 3201 — Wheel sensor rear axle left
- 3201 — Solenoid valve 2/2 left REAR AXLE
- 3201 — Valve output 1
- 3201 — CAN data bus: Astronic message ETC1, bytes 5 and 6
- 3201 — Charge air pressure
- 3201 — Low pressure in air filter