3460 — CAN data bus: Time overrun when receiving
| Meaning | CAN data bus: Time overrun when receiving. |
| System | FFR |
| Family | Manufacturer-native code |
How to read code 3460
Code 3460 is a native MAN code of the "FFR" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 3460 mean?
CAN data bus: Time overrun when receiving. (System: FFR)
Can I keep driving with code 3460 active?
With caution: limp mode possible, have it checked soon
How do you fix code 3460?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (FFR)
- 3001 — Term. 30, continuous positive
- 3010 — Torque and engine speed limiting system
- 3011 — EVB pressure sensor
- 3020 — Accelerator pedal, PWM1 signal
- 3021 — Accelerator pedal, PWM2 signal
- 3022 — Accelerator pedal, PWM1 and PWM2 signal
- 3060 — Engine CAN sending message timeout (time overrun).
- 3061 — CAN data bus: Time overrun when receiving
- 3062 — CAN data bus: Time overrun when receiving
- 3063 — CAN data bus: Time overrun when receiving
- Previous code: 3459 — CAN data bus: ACC message TSC1-ACC,
- Next code: 3461 — ESP EOL data in the EBS ECU
Related codes
- 34 — Stop request display door 5
- 3400 — Trailer control module, no fault
- 3400 — Flame start solenoid valve
- 3401 — Trailer control module control electronics,
- 3401 — Engine oil level too high/low (static)
- 3401 — Flame start relay
- 3402 — Throttle butterfly position deviation
- 3402 — Trailer control module
- 3402 — Engine oil level too high (dynamic)
- 3402 — Flame glow plug current
- 3403 — Throttle butterfly output stage switched off
- 3403 — Trailer control module control electronics,