4023 — Speed signals implausible
| Meaning | Speed signals implausible. |
| System | HVA |
| Family | Manufacturer-native code |
How to read code 4023
Code 4023 is a native MAN code of the "HVA" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 4023 mean?
Speed signals implausible. (System: HVA)
Can I keep driving with code 4023 active?
With caution: limp mode possible, have it checked soon
How do you fix code 4023?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (HVA)
- 4004 — EEPROM error
- 4007 — Failure of CAN message CCVeh_Speed
- 4008 — Failure of CAN message EBC2
- 4009 — Failure of CAN message EEC1
- 4010 — Failure of CAN message EBC1
- 4011 — ABS signals 'Not fully operational'
- 4012 — Cable fault oil temperature sensor (pin III/3 or IV/18)
- 4013 — Oil pressure sensor signals 'No oil pressure'
- 4014 — Oil pressure sensor signals 'Continuous oil pressure'
- 4015 — Cable fault oil pressure sensor (pin III/4, II/5 or I/5)
- Previous code: 4022 — High beam 2 right
- Next code: 4024 — Central control unit EEPROM: Checksum error in
Related codes
- 40 — Workshop switch door 1
- 4000 — Foot off accelerator pedal
- 4000 — Communication fault to CRT control unit
- 4000 — No response to DM4 request to control unit 0
- 4000 — External lighting
- 4000 — Headlight low beam
- 4001 — Low air pressure
- 4001 — Central control unit - A-controller: Checksum error in
- 4001 — Exhaust temperature too high or communication
- 4001 — Accumulator charge valve
- 4001 — Selector lever position
- 4001 — Headlight low beam, left