4591 — Solenoid valve RBG
| Meaning | Solenoid valve RBG. |
| System | DIW5 |
| Family | Manufacturer-native code |
How to read code 4591
Code 4591 is a native MAN code of the "DIW5" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 4591 mean?
Solenoid valve RBG. (System: DIW5)
Can I keep driving with code 4591 active?
With caution: limp mode possible, have it checked soon
How do you fix code 4591?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (DIW5)
- 120 — Temperature acquisition retarder oil
- 4502 — Turbine speed acquisition
- 4509 — Central solenoid valve handler
- 4570 — Solenoid valve WP
- 4600 — Input signal ABS
- 4612 — Input signal ABS
- 4700 — Unknown engine load source
- 4707 — Engine load source CAN: Error in engine map
- 4708 — Engine load source CAN
- 4711 — Engine load source Bosch EDC
- Previous code: 4590 — Central control unit - B-controller: Incorrect fun...
- Next code: 4592 — Central control unit - A-controller
Related codes
- 45 — Pressure shaft door 1
- 4500 — Internal system error, Trap NMI
- 4500 — Brake pad wear sensor wheel 4
- 4500 — Steering/trailing axle/anti-jacknife protection
- 4500 — Steering oil level too low
- 4501 — Internal system error, Stack overflow
- 4501 — Pressure module supply cable to wheel 6
- 4502 — Internal system error, Stack underflow
- 4502 — Turbine speed acquisition
- 4502 — Brake pad wear sensor wheel 5
- 4502 — Power steering oil level circuit 2
- 4503 — Internal system error, Trap ILLBUS