8102 — Control unit defective; calibration data
| Meaning | Control unit defective; calibration data. |
| System | ECAM |
| Family | Manufacturer-native code |
How to read code 8102
Code 8102 is a native MAN code of the "ECAM" system: it is stored by the vehicle control unit and is read with a diagnostic tool that supports the manufacturer protocol, not with a generic OBD reader. This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code 8102 mean?
Control unit defective; calibration data. (System: ECAM)
Can I keep driving with code 8102 active?
With caution: limp mode possible, have it checked soon
How do you fix code 8102?
Diagnosis starts from reading the live ECU parameters: the code points to the fault area, not to the part to replace. A vehicle-electronics specialist can test the component and clear the code after the repair.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usOther codes of the same control unit (ECAM)
- 8010 — Pressure below warning level
- 8011 — Initial filling of circuit 1 – faulty
- 8012 — Initial filling of circuit 2 – faulty
- 8013 — Initial filling of circuit 3 – faulty
- 8014 — Initial filling of circuit 4 – faulty
- 8020 — No valid fault definition
- 8100 — Control unit defective; ROM checksum incorrect
- 8101 — Control unit defective; RAM fault
- 8103 — Control unit defective; parameter data
- 8104 — Pressure, pressure sensor – preliminary
- Previous code: 8101 — Failure of all CAN messages, but no BUSOFF
- Next code: 8103 — Control unit defective; parameter data
Related codes
- 81 — Exhaust differential pressure
- 81 — Door sensor door 1 rear
- 8100 — Control unit defective; ROM checksum incorrect
- 8101 — Control unit defective; RAM fault
- 8101 — Total failure of CAN messages
- 8101 — Failure of all CAN messages, but no BUSOFF
- 8103 — Control unit defective; parameter data
- 8103 — CAN message tachograph
- 8103 — Failure of message TCO1 (speed, reset trip counter)
- 8104 — Pressure, pressure sensor – preliminary
- 8104 — CAN message tachograph: Route information
- 8104 — Failure of Vehicle Distance message