P0214 — Cold start injector 2 malfunction
| Meaning | The control unit detected a fault in the second cold start injector, used on some engines to enrich the mixture when the engine is cold. The code is standard, but not every engine has this part and how it works varies by make. |
| Family | Powertrain (P) |
Typical symptoms
Check engine light on
Uneven idle after start-up
Fuel smell at start-up
Hesitation in the first accelerations
Common causes
Damaged wiring or connector
Faulty injector relay or control module
Engine temperature sensor reporting a wrong value
Fuel leak at the injector or its fitting
What to do
How to read code P0214
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0214 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (14) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0214 mean?
Cold start injector 2 malfunction. The control unit detected a fault in the second cold start injector, used on some engines to enrich the mixture when the engine is cold. The code is standard, but not every engine has this part and how it works varies by make.
Can I keep driving with code P0214 active?
With caution: limp mode possible, have it checked soon
Common causes — P0214
Faulty or dirty cold start injector Damaged wiring or connector Faulty injector relay or control module Engine temperature sensor reporting a wrong value Fuel leak at the injector or its fitting
How do you fix code P0214?
Check the connector, wiring and sealing of the injector. If there are no leaks the car can be used for short trips, but have the fault looked at soon: hard cold starts wear the engine and the battery.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0213 — Cold start injector 1 malfunction
- Next code: P0215 — Engine Shutoff Solenoid Malfunction
Related codes
- P0200 — Injector circuit: general electrical fault
- P0201 — Injector cylinder 1: circuit
- P0202 — Injector circuit cylinder 2: electrical fault
- P0203 — Injector circuit cylinder 3: electrical fault
- P0204 — Injector circuit cylinder 4: electrical fault
- P0205 — Injector circuit cylinder 5: electrical fault
- P0206 — Injector circuit cylinder 6: electrical fault
- P0207 — Injector circuit cylinder 7: electrical fault
- P0208 — Injector circuit cylinder 8: electrical fault
- P0209 — Injector circuit cylinder 9: electrical fault
- P020A — Injector 1: performance out of range
- P020B — Injector 2: performance out of range