Skip to content
Fault code dictionary (DTC)

P021E — Cylinder 11 injection timing out of range

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected that the injection moment in cylinder 11 does not match the one requested. The code is standard, but the monitoring details vary from one manufacturer to another. It affects engines with at least 11 cylinders.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Noisy or uneven engine
Loss of power
Abnormal exhaust smoke
Unstable idle
Slow starting

Common causes

Worn or faulty cylinder 11 injector
Wrong signal from the speed or phase sensors
Wiring or connector in poor condition
Irregular fuel supply pressure
Mechanical timing problem
Internal control unit fault

What to do

Have the cylinder 11 injector, the wiring and the speed and phase sensors checked. If the engine knocks or runs very unevenly, avoid using the car until it has been checked.

How to read code P021E

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P021E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (1E) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P021E mean?

Cylinder 11 injection timing out of range. The control unit detected that the injection moment in cylinder 11 does not match the one requested. The code is standard, but the monitoring details vary from one manufacturer to another. It affects engines with at least 11 cylinders.

Can I keep driving with code P021E active?

With caution: limp mode possible, have it checked soon

Common causes — P021E

Worn or faulty cylinder 11 injector Wrong signal from the speed or phase sensors Wiring or connector in poor condition Irregular fuel supply pressure Mechanical timing problem Internal control unit fault

How do you fix code P021E?

Have the cylinder 11 injector, the wiring and the speed and phase sensors checked. If the engine knocks or runs very unevenly, avoid using the car until it has been checked.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes