P0257 — Injection pump fuel metering circuit B: performance out of range
| Meaning | The control unit detected that fuel metering in the injection pump (circuit B) is not following what was requested: the actual value differs from the commanded one. The circuit may be electrically fine while the pump fails to respond properly. What circuit B means depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Unstable idle
Fuel use that may seem irregular
Check engine light on
Exhaust smoke
Common causes
Internal wear in the injection pump
Fuel supply problems, such as a clogged filter or air in the system
Electrical connections with excessive resistance
Calibration or fault in the control unit (rare)
What to do
How to read code P0257
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0257 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (57) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0257 mean?
Injection pump fuel metering circuit B: performance out of range. The control unit detected that fuel metering in the injection pump (circuit B) is not following what was requested: the actual value differs from the commanded one. The circuit may be electrically fine while the pump fails to respond properly. What circuit B means depends on the manufacturer.
Can I keep driving with code P0257 active?
With caution: limp mode possible, have it checked soon
Common causes — P0257
Dirty, worn or sluggish metering unit Internal wear in the injection pump Fuel supply problems, such as a clogged filter or air in the system Electrical connections with excessive resistance Calibration or fault in the control unit (rare)
How do you fix code P0257?
First check the condition of the fuel filter and make sure no air is entering the system, as these are simple checks. Then have the pump data read with suitable equipment. Avoid prolonged heavy loads until it is clarified.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0256 — Injection pump fuel metering circuit B: malfunctio...
- Next code: P0258 — Injection pump fuel metering circuit B: signal too...
Related codes
- P0200 — Injector circuit: general electrical fault
- P0201 — Injector cylinder 1: circuit
- P0202 — Injector circuit cylinder 2: electrical fault
- P0203 — Injector circuit cylinder 3: electrical fault
- P0204 — Injector circuit cylinder 4: electrical fault
- P0205 — Injector circuit cylinder 5: electrical fault
- P0206 — Injector circuit cylinder 6: electrical fault
- P0207 — Injector circuit cylinder 7: electrical fault
- P0208 — Injector circuit cylinder 8: electrical fault
- P0209 — Injector circuit cylinder 9: electrical fault
- P020A — Injector 1: performance out of range
- P020B — Injector 2: performance out of range