Skip to content
Fault code dictionary (DTC)

P0289 — Cylinder 10 injector circuit voltage too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer detected a voltage that is too high in the circuit controlling the cylinder 10 injector. The signal is outside its expected range and the injector may not open properly. It applies to engines with at least 10 cylinders.
FamilyPowertrain (P)

Typical symptoms

Engine jerking or running rough
Loss of power
Unstable idle
Smell of unburnt fuel
Check engine light on

Common causes

Damaged injector wiring touching a power supply
Loose or corroded injector connector
Cylinder 10 injector faulty internally
Faulty injector driver in the computer (rare)

What to do

Have the connector and wiring of the cylinder 10 injector checked first. If the light is flashing, do not carry on driving, to avoid damaging the catalytic converter.

How to read code P0289

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0289 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (89) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0289 mean?

Cylinder 10 injector circuit voltage too high. The engine computer detected a voltage that is too high in the circuit controlling the cylinder 10 injector. The signal is outside its expected range and the injector may not open properly. It applies to engines with at least 10 cylinders.

Can I keep driving with code P0289 active?

With caution: limp mode possible, have it checked soon

Common causes — P0289

Damaged injector wiring touching a power supply Loose or corroded injector connector Cylinder 10 injector faulty internally Faulty injector driver in the computer (rare)

How do you fix code P0289?

Have the connector and wiring of the cylinder 10 injector checked first. If the light is flashing, do not carry on driving, to avoid damaging the catalytic converter.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes