P02F7 — Cylinder 10 injector circuit out of range or performing poorly
| Meaning | The engine control unit found that the electrical circuit of the cylinder 10 injector is outside its expected values or is not responding as it should. The injector may be at fault, but wiring or connectors can cause the same code. Cylinder numbering is set by the manufacturer, so it must be confirmed for your make. |
| Family | Powertrain (P) |
Typical symptoms
Rough running or vibration at idle
Loss of power
Hard cold starting
Fuel consumption that seems higher than usual
Common causes
Injector wire with damaged insulation or a break
Injector with a faulty internal winding
Insufficient power or ground supply to the injector circuit
Failed driver stage inside the control unit
What to do
How to read code P02F7
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P02F7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (F7) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P02F7 mean?
Cylinder 10 injector circuit out of range or performing poorly. The engine control unit found that the electrical circuit of the cylinder 10 injector is outside its expected values or is not responding as it should. The injector may be at fault, but wiring or connectors can cause the same code. Cylinder numbering is set by the manufacturer, so it must be confirmed for your make.
Can I keep driving with code P02F7 active?
With caution: limp mode possible, have it checked soon
Common causes — P02F7
Corroded or poorly seated injector connector Injector wire with damaged insulation or a break Injector with a faulty internal winding Insufficient power or ground supply to the injector circuit Failed driver stage inside the control unit
How do you fix code P02F7?
Have the connector and wiring of the cylinder 10 injector checked first, then measure the injector's resistance. Do not ignore the warning light: drive gently and have the fault looked at soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P02F6 — Cylinder 9 injector circuit out of range or perfor...
- Next code: P02F8 — Cylinder 11 injector circuit out of range or perfo...
Related codes
- P0200 — Injector circuit: general electrical fault
- P0201 — Injector cylinder 1: circuit
- P0202 — Injector circuit cylinder 2: electrical fault
- P0203 — Injector circuit cylinder 3: electrical fault
- P0204 — Injector circuit cylinder 4: electrical fault
- P0205 — Injector circuit cylinder 5: electrical fault
- P0206 — Injector circuit cylinder 6: electrical fault
- P0207 — Injector circuit cylinder 7: electrical fault
- P0208 — Injector circuit cylinder 8: electrical fault
- P0209 — Injector circuit cylinder 9: electrical fault
- P020A — Injector 1: performance out of range
- P020B — Injector 2: performance out of range