P02FB — Cold start fuel injection control circuit open
| Meaning | Some engines have a dedicated system that adds fuel for cold starting. The control unit found that the control circuit of this system is broken or does not complete the connection. How the system works and where it sits depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Hard starting when the engine is cold
Uneven idle in the first few minutes
Smoke or smell of fuel when cold
The engine may run normally when warm
Common causes
Broken wire in the circuit
Cold start component with an open coil
No power reaching the circuit
Failed driver stage in the control unit
What to do
How to read code P02FB
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P02FB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (FB) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P02FB mean?
Cold start fuel injection control circuit open. Some engines have a dedicated system that adds fuel for cold starting. The control unit found that the control circuit of this system is broken or does not complete the connection. How the system works and where it sits depends on the manufacturer.
Can I keep driving with code P02FB active?
With caution: limp mode possible, have it checked soon
Common causes — P02FB
Cold start injector or valve connector unplugged or corroded Broken wire in the circuit Cold start component with an open coil No power reaching the circuit Failed driver stage in the control unit
How do you fix code P02FB?
Check the connector and wiring of the cold start component first, then the continuity of its winding. You will mostly notice it on cold mornings: it is not urgent if the car starts, but have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P02FA — Diesel intake air flow valve: min/max stop positio...
- Next code: P02FC — Cold start fuel injection control circuit low
Related codes
- P0200 — Injector circuit: general electrical fault
- P0201 — Injector cylinder 1: circuit
- P0202 — Injector circuit cylinder 2: electrical fault
- P0203 — Injector circuit cylinder 3: electrical fault
- P0204 — Injector circuit cylinder 4: electrical fault
- P0205 — Injector circuit cylinder 5: electrical fault
- P0206 — Injector circuit cylinder 6: electrical fault
- P0207 — Injector circuit cylinder 7: electrical fault
- P0208 — Injector circuit cylinder 8: electrical fault
- P0209 — Injector circuit cylinder 9: electrical fault
- P020A — Injector 1: performance out of range
- P020B — Injector 2: performance out of range