P0583 — Cruise control vacuum control circuit low
| Meaning | The control unit reads a lower than normal voltage on the cruise control vacuum control circuit. It is usually a wire shorted to ground or a coil with an internal short. It applies to vehicles with a vacuum-operated cruise actuator. |
| Family | Powertrain (P) |
Typical symptoms
Check engine light on
Cruise does not hold speed
Blown fuse in the circuit
Cruise fault message
Common causes
Vacuum solenoid with an internal short
Corroded connector or water in it
Damaged or pinched wiring
Internal control unit fault, which is rare
What to do
How to read code P0583
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0583 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (83) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0583 mean?
Cruise control vacuum control circuit low. The control unit reads a lower than normal voltage on the cruise control vacuum control circuit. It is usually a wire shorted to ground or a coil with an internal short. It applies to vehicles with a vacuum-operated cruise actuator.
Can I keep driving with code P0583 active?
With caution: limp mode possible, have it checked soon
Common causes — P0583
Vacuum control wire touching ground Vacuum solenoid with an internal short Corroded connector or water in it Damaged or pinched wiring Internal control unit fault, which is rare
How do you fix code P0583?
Check the wiring and connector of the solenoid, looking for damaged wires, and check the fuse. You can drive, but without cruise control. Repair the cause instead of just clearing the code.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0582 — Cruise control vacuum control circuit open
- Next code: P0584 — Cruise control vacuum control circuit high
Related codes
- P0500 — Vehicle Speed Sensor Malfunction
- P0501 — Vehicle speed sensor: implausible value
- P0502 — Vehicle speed sensor circuit low input
- P0503 — Vehicle speed sensor intermittent, erratic or high
- P0504 — Brake Switch Correlation Error
- P0505 — Idle Control System Malfunction
- P0506 — Idle speed lower than expected
- P0507 — Idle Control System RPM Higher Than Expected
- P0508 — Idle air control circuit low
- P0509 — Idle air control circuit high
- P050A — Cold start idle control system performance
- P050B — Cold start ignition timing performance