P0585 — Cruise control multi-function inputs A/B correlation
| Meaning | The control unit is getting signals from the two cruise control multi-function inputs A and B that do not agree with each other. The two circuits should give consistent information, and if they do not, the system does not trust the controls. Which button each input corresponds to depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Check engine light on
Cruise buttons responding strangely
Commands carried out halfway or with a delay
Cruise control fault message
Common causes
One of the two circuits with a poor connector or wire
Worn steering wheel clockspring
Abnormal resistance in the controls wiring
Faulty switch
Internal control unit fault, which is rare
What to do
How to read code P0585
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0585 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (85) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0585 mean?
Cruise control multi-function inputs A/B correlation. The control unit is getting signals from the two cruise control multi-function inputs A and B that do not agree with each other. The two circuits should give consistent information, and if they do not, the system does not trust the controls. Which button each input corresponds to depends on the manufacturer.
Can I keep driving with code P0585 active?
With caution: limp mode possible, have it checked soon
Common causes — P0585
Cruise switch pad with dirty or worn contacts One of the two circuits with a poor connector or wire Worn steering wheel clockspring Abnormal resistance in the controls wiring Faulty switch Internal control unit fault, which is rare
How do you fix code P0585?
Check the cleanliness and condition of the connectors and switch pad, then the wiring of both circuits. You can drive normally. If the problem persists, the signals need to be checked with a diagnostic tool.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0584 — Cruise control vacuum control circuit high
- Next code: P0586 — Cruise control vent control circuit open
Related codes
- P0500 — Vehicle Speed Sensor Malfunction
- P0501 — Vehicle speed sensor: implausible value
- P0502 — Vehicle speed sensor circuit low input
- P0503 — Vehicle speed sensor intermittent, erratic or high
- P0504 — Brake Switch Correlation Error
- P0505 — Idle Control System Malfunction
- P0506 — Idle speed lower than expected
- P0507 — Idle Control System RPM Higher Than Expected
- P0508 — Idle air control circuit low
- P0509 — Idle air control circuit high
- P050A — Cold start idle control system performance
- P050B — Cold start ignition timing performance