P059E — Active grille air shutter A position sensor circuit intermittent
| Meaning | The control unit found that the signal from the position sensor of active grille shutter A, the slats in front of the radiator, comes and goes. The fault is not constant, so it can vanish and come back. A contact that moves with vibration is often involved. |
| Family | Powertrain (P) |
Typical symptoms
Grille slats sometimes not responding
Engine temperature varying oddly
Cooling fan starting in fits
Problem appearing on rough roads
Common causes
Wiring with a nearly broken wire
Position sensor with an unstable internal contact
Moisture in the connector
Shutter actuator causing interference
Unstable ground or supply to the circuit
What to do
How to read code P059E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P059E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (9E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P059E mean?
Active grille air shutter A position sensor circuit intermittent. The control unit found that the signal from the position sensor of active grille shutter A, the slats in front of the radiator, comes and goes. The fault is not constant, so it can vanish and come back. A contact that moves with vibration is often involved.
Can I keep driving with code P059E active?
With caution: limp mode possible, have it checked soon
Common causes — P059E
Loose or corroded connector Wiring with a nearly broken wire Position sensor with an unstable internal contact Moisture in the connector Shutter actuator causing interference Unstable ground or supply to the circuit
How do you fix code P059E?
Have the connections checked first and the wiring gently moved while reading data, to bring the fault out. An intermittent fault tends to get worse, so do not put it off too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P059D — Active grille air shutter A position sensor circui...
- Next code: P059F — Active grille shutter A: stuck open or performance...
Related codes
- P0500 — Vehicle Speed Sensor Malfunction
- P0501 — Vehicle speed sensor: implausible value
- P0502 — Vehicle speed sensor circuit low input
- P0503 — Vehicle speed sensor intermittent, erratic or high
- P0504 — Brake Switch Correlation Error
- P0505 — Idle Control System Malfunction
- P0506 — Idle speed lower than expected
- P0507 — Idle Control System RPM Higher Than Expected
- P0508 — Idle air control circuit low
- P0509 — Idle air control circuit high
- P050A — Cold start idle control system performance
- P050B — Cold start ignition timing performance