P05DB — Brake pedal sensor B: open circuit
| Meaning | The control unit found that the circuit of the second brake pedal position sensor (sensor B) is broken or open. It no longer receives the signal telling it how far you are pressing the pedal. Many cars use two sensors to cross-check each other, so the system may switch to a safe mode. |
| Family | Powertrain (P) |
Typical symptoms
Brake lights not working or staying on all the time
Cruise control not engaging or switching off
Engine hard to start or not starting without pressing the brake
Reduced performance or odd throttle response
On hybrids, uneven regenerative braking
Common causes
Broken or damaged wire near the pedal
Faulty brake pedal sensor
Missing power or ground to the sensor
Control unit fault (rare)
What to do
How to read code P05DB
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P05DB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (DB) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P05DB mean?
Brake pedal sensor B: open circuit. The control unit found that the circuit of the second brake pedal position sensor (sensor B) is broken or open. It no longer receives the signal telling it how far you are pressing the pedal. Many cars use two sensors to cross-check each other, so the system may switch to a safe mode.
Can I keep driving with code P05DB active?
With caution: limp mode possible, have it checked soon
Common causes — P05DB
Loose, corroded or spread connector terminals at the sensor Broken or damaged wire near the pedal Faulty brake pedal sensor Missing power or ground to the sensor Control unit fault (rare)
How do you fix code P05DB?
Have the brake lights checked right away, since they matter for the safety of drivers behind you. Start with the sensor connector and wiring under the dash, then check the sensor's supply and ground. Don't leave it too long, as the car may have limited functions.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P05DA — PCV regulator valve control circuit high
- Next code: P05DC — Brake pedal sensor B: signal out of range
Related codes
- P0500 — Vehicle Speed Sensor Malfunction
- P0501 — Vehicle speed sensor: implausible value
- P0502 — Vehicle speed sensor circuit low input
- P0503 — Vehicle speed sensor intermittent, erratic or high
- P0504 — Brake Switch Correlation Error
- P0505 — Idle Control System Malfunction
- P0506 — Idle speed lower than expected
- P0507 — Idle Control System RPM Higher Than Expected
- P0508 — Idle air control circuit low
- P0509 — Idle air control circuit high
- P050A — Cold start idle control system performance
- P050B — Cold start ignition timing performance