P079D — Transmission friction element D slip detected
| Meaning | The control module detected that an internal friction element of the gearbox, a clutch or brake, is slipping more than allowed. The letter D is a label chosen by the manufacturer and I have no reliable information on which element it is on your brand. It points to wear or insufficient oil pressure. |
| Family | Powertrain (P) |
Typical symptoms
Delayed or jerky shifts
Loss of power in some gears
Burnt smell from the oil
Gearbox in limp mode
Transmission or check engine light on
Common causes
Insufficient oil pressure
Faulty solenoid or valve body
Worn clutch or plates
Clogged filter
Damaged internal seals
What to do
How to read code P079D
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P079D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (9D) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P079D mean?
Transmission friction element D slip detected. The control module detected that an internal friction element of the gearbox, a clutch or brake, is slipping more than allowed. The letter D is a label chosen by the manufacturer and I have no reliable information on which element it is on your brand. It points to wear or insufficient oil pressure.
Can I keep driving with code P079D active?
With caution: limp mode possible, have it checked soon
Common causes — P079D
Low, degraded or burnt gearbox oil Insufficient oil pressure Faulty solenoid or valve body Worn clutch or plates Clogged filter Damaged internal seals
How do you fix code P079D?
Start by checking the gearbox oil level and condition. Do not ignore the code: use the car less, avoid loads and hard acceleration, and have the gearbox diagnosed as soon as possible.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P079C — Transmission friction element C slip detected
- Next code: P079E — Transmission friction element E slip detected
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible