Skip to content
Fault code dictionary (DTC)

P07C2 — Input shaft speed sensor B: signal high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe transmission control unit detected a signal that is too high from sensor B, which measures input shaft or turbine shaft speed. The value does not match the other transmission data. The control unit cannot trust this measurement to manage shifts.
FamilyPowertrain (P)

Typical symptoms

Transmission or check engine light on
Harsh or mistimed shifts
Transmission stuck in one gear
Erratic speedometer or tachometer
Transmission limp mode

Common causes

Sensor B wiring shorted to power
Damaged cable introducing electrical noise
Faulty speed sensor
Dirty or damaged connector
Metal debris in the transmission
Faulty transmission control unit, which is rare

What to do

Have the wiring and connector of sensor B inspected and the values compared with the other speed sensors. If the transmission jerks or stays in limp mode, limit use of the car and have it checked soon.

How to read code P07C2

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P07C2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (C2) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P07C2 mean?

Input shaft speed sensor B: signal high. The transmission control unit detected a signal that is too high from sensor B, which measures input shaft or turbine shaft speed. The value does not match the other transmission data. The control unit cannot trust this measurement to manage shifts.

Can I keep driving with code P07C2 active?

With caution: limp mode possible, have it checked soon

Common causes — P07C2

Sensor B wiring shorted to power Damaged cable introducing electrical noise Faulty speed sensor Dirty or damaged connector Metal debris in the transmission Faulty transmission control unit, which is rare

How do you fix code P07C2?

Have the wiring and connector of sensor B inspected and the values compared with the other speed sensors. If the transmission jerks or stays in limp mode, limit use of the car and have it checked soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes