P07C4 — Input shaft speed sensor C: signal high
| Meaning | The transmission control unit detected a signal that is too high from sensor C, which measures input shaft or turbine shaft speed. The value is not consistent with the other data. The exact role of sensor C depends on the type of transmission. |
| Family | Powertrain (P) |
Typical symptoms
Harsh or mistimed shifts
Transmission stuck in one gear
Erratic speedometer or tachometer
Transmission limp mode
Common causes
Damaged cable creating electrical noise
Faulty speed sensor
Dirty or damaged connector
Metal debris in the transmission
Faulty transmission control unit, which is rare
What to do
How to read code P07C4
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07C4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (C4) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07C4 mean?
Input shaft speed sensor C: signal high. The transmission control unit detected a signal that is too high from sensor C, which measures input shaft or turbine shaft speed. The value is not consistent with the other data. The exact role of sensor C depends on the type of transmission.
Can I keep driving with code P07C4 active?
With caution: limp mode possible, have it checked soon
Common causes — P07C4
Sensor C wiring shorted to power Damaged cable creating electrical noise Faulty speed sensor Dirty or damaged connector Metal debris in the transmission Faulty transmission control unit, which is rare
How do you fix code P07C4?
Have the wiring and connector of sensor C inspected and the values compared with the other speed sensors. If the transmission is in limp mode or jerking, limit use of the car and have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07C3 — Input shaft speed sensor C: signal low
- Next code: P07C5 — Intermediate shaft speed sensor A: signal low
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible