Skip to content
Fault code dictionary (DTC)

P07C9 — Intermediate shaft speed sensor C: signal low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe transmission control unit detected a signal that is too low from sensor C, which measures the speed of the intermediate shaft. The exact role of sensor C depends on the type of transmission, since not all have three sensors on this shaft. A weak or missing reading makes shift management less precise.
FamilyPowertrain (P)

Typical symptoms

Transmission or check engine light on
Harsh or late shifts
Transmission stuck in one gear
Felt slipping
Transmission limp mode

Common causes

Sensor C wiring damaged or shorted to ground
Corroded or loose connector
Faulty speed sensor
Metal debris on the sensor tip
Low or degraded transmission fluid
Faulty transmission control unit, which is rare

What to do

Have the wiring and connector of sensor C checked, then the level and condition of the transmission fluid. If the transmission slips or stays in limp mode, do not keep pushing on with driving.

How to read code P07C9

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P07C9 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (C9) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P07C9 mean?

Intermediate shaft speed sensor C: signal low. The transmission control unit detected a signal that is too low from sensor C, which measures the speed of the intermediate shaft. The exact role of sensor C depends on the type of transmission, since not all have three sensors on this shaft. A weak or missing reading makes shift management less precise.

Can I keep driving with code P07C9 active?

With caution: limp mode possible, have it checked soon

Common causes — P07C9

Sensor C wiring damaged or shorted to ground Corroded or loose connector Faulty speed sensor Metal debris on the sensor tip Low or degraded transmission fluid Faulty transmission control unit, which is rare

How do you fix code P07C9?

Have the wiring and connector of sensor C checked, then the level and condition of the transmission fluid. If the transmission slips or stays in limp mode, do not keep pushing on with driving.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes