P07CC — Transmission mode switch C: circuit signal low
| Meaning | The transmission control unit is getting a lower voltage than expected from mode switch C. Which component is switch C is defined by the manufacturer, and I have no reliable information to name it on a specific make. In practice the unit cannot be sure which driving mode has been selected. |
| Family | Powertrain (P) |
Typical symptoms
Drive mode that does not respond to the selector
Gearbox going into limp mode
Gears stuck or shifting oddly
Gear indicator on the dash wrong or missing
Common causes
Corroded or loose connector
Worn or faulty switch
Moisture or spilled liquid in the control
Faulty transmission control unit, less common
What to do
How to read code P07CC
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07CC starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (CC) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07CC mean?
Transmission mode switch C: circuit signal low. The transmission control unit is getting a lower voltage than expected from mode switch C. Which component is switch C is defined by the manufacturer, and I have no reliable information to name it on a specific make. In practice the unit cannot be sure which driving mode has been selected.
Can I keep driving with code P07CC active?
With caution: limp mode possible, have it checked soon
Common causes — P07CC
Switch wiring shorted to ground or damaged Corroded or loose connector Worn or faulty switch Moisture or spilled liquid in the control Faulty transmission control unit, less common
How do you fix code P07CC?
First check the switch connectors and wiring for moisture, corrosion or pinched wires. If the gearbox has gone into limp mode, avoid long trips and have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07CB — Transmission fluid thermostat not performing corre...
- Next code: P07CD — Transmission mode switch C: circuit signal high
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible