P07D5 — Transmission mode switch F: circuit signal low
| Meaning | The transmission control unit is reading a lower than normal voltage from mode switch F. The meaning of the letter F is set by the manufacturer, and I have no reliable information to name it on a specific make. The selected mode is not recognized with certainty. |
| Family | Powertrain (P) |
Typical symptoms
Drive mode not responding
Gearbox in limp mode
Irregular shifting
Wrong gear indication on the dash
Common causes
Corroded connector
Faulty switch
Moisture or liquid in the control
Faulty transmission control unit, less common
What to do
How to read code P07D5
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07D5 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (D5) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07D5 mean?
Transmission mode switch F: circuit signal low. The transmission control unit is reading a lower than normal voltage from mode switch F. The meaning of the letter F is set by the manufacturer, and I have no reliable information to name it on a specific make. The selected mode is not recognized with certainty.
Can I keep driving with code P07D5 active?
With caution: limp mode possible, have it checked soon
Common causes — P07D5
Wiring shorted to ground or damaged Corroded connector Faulty switch Moisture or liquid in the control Faulty transmission control unit, less common
How do you fix code P07D5?
Start with the switch connectors and wiring, looking for corrosion or pinched wires. If the gearbox is restricted, avoid long trips and have it checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P07D4 — Transmission mode switch F: circuit fault
- Next code: P07D6 — Transmission mode switch F: circuit signal high
Related codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible