P07E6 — Transmission stuck in Park
| Meaning | The control unit detects that the gearbox stays in Park even when the driver has asked to leave it. The parking lock or the selection system is not releasing. The car may stay put and be impossible to move. |
| Family | Powertrain (P) |
Typical symptoms
The car does not move after selecting Drive or reverse
Selector stiff or unresponsive
A dashboard message about the gearbox
Transmission or check engine light on
Common causes
Range position sensor or selector faulty
Selector cable or linkage out of adjustment or damaged
Brake interlock not working (for example the brake pedal signal)
Weak battery or supply problems
Internal fault in the transmission control unit
What to do
How to read code P07E6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P07E6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (7) points to transmission, and the last two (E6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P07E6 mean?
Transmission stuck in Park. The control unit detects that the gearbox stays in Park even when the driver has asked to leave it. The parking lock or the selection system is not releasing. The car may stay put and be impossible to move.
Can I keep driving with code P07E6 active?
With caution: limp mode possible, have it checked soon
Common causes — P07E6
Parking lock or its actuator not releasing Range position sensor or selector faulty Selector cable or linkage out of adjustment or damaged Brake interlock not working (for example the brake pedal signal) Weak battery or supply problems Internal fault in the transmission control unit
How do you fix code P07E6?
Check that the brake pedal is pressed and that the battery is in good condition, as these are simple but common causes. If the selector stays stuck, do not force it: call in a workshop.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usRelated codes
- P0700 — Transmission control system: MIL request
- P0701 — Transmission control system: performance outside expected ra...
- P0702 — Transmission control system: electrical fault
- P0703 — Torque converter/brake switch B circuit fault
- P0704 — Clutch switch input circuit fault
- P0705 — Transmission range sensor (PRNDL) circuit fault
- P0706 — Transmission range sensor: signal not plausible
- P0707 — Transmission range sensor circuit: signal too low
- P0708 — Transmission range sensor circuit: signal too high
- P0709 — Transmission range sensor circuit: intermittent signal
- P070A — Transmission fluid level sensor circuit fault
- P070B — Transmission fluid level sensor: reading not plausible